Mast Base Bolts

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   We raised the mast Sunday and this must be the first time that I was the one installing the 2 mast base bolts down thru the plate. 
I noticed that there are shoulders on the bolts which fit into the mast base slots but don't fit into the holes in the cabin top plate. This prevents the bolt head from snugging down on the mast base plate. One washer is not enough to fill the gap so I need another washer or a bolt with no shoulder. 
I'm just curious and wanted to check with the group if there are special bolts or regular bolts will be ok. 
Thanks in advance, John

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
fatjohnz Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 05 August 2006 Location: United States Status: Offline Points: 304	Post Options Post Reply Quote fatjohnz Report Post Thanks(0) Quote Reply Topic: Mast Base Bolts Posted: 02 May 2016 at 10:00am
	We raised the mast Sunday and this must be the first time that I was the one installing the 2 mast base bolts down thru the plate. I noticed that there are shoulders on the bolts which fit into the mast base slots but don't fit into the holes in the cabin top plate. This prevents the bolt head from snugging down on the mast base plate. One washer is not enough to fill the gap so I need another washer or a bolt with no shoulder. I'm just curious and wanted to check with the group if there are special bolts or regular bolts will be ok. Thanks in advance, John

Bill Layton Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 15 September 2002 Location: Canada Status: Offline Points: 551	Post Options Post Reply Quote Bill Layton Report Post Thanks(0) Quote Reply Posted: 02 May 2016 at 10:25am
	It's a special made custom bolt. Above the plate it's 1/2" thread and going thru the deck and inside it's 3/8" thread. They are supposed to stay in place and you only remove the 1/2" nuts outside. But because the bolt is stainless and the nuts are stainless if you tighten them too much they jam and then owners undo the inside 3/8" nut and remove the bolt instead.

fatjohnz Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 05 August 2006 Location: United States Status: Offline Points: 304	Post Options Post Reply Quote fatjohnz Report Post Thanks(0) Quote Reply Posted: 02 May 2016 at 11:14am
	Ah; thanks Bill. Sounds like my options are (1)try to free the 1/2" nut and attempt to re-tighten (2) put another washer under the 1/2" nut (3) replace the bolts and nuts.