|
Sail drive screw shaft |
Post Reply 
|
| Author | |
Seawolf 
Commodore 
Joined: 15 March 2012 Location: missoula Status: Offline Points: 118 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Sail drive screw shaftPosted: 05 October 2015 at 8:31pm |
|
Yesterday I winterized the Laser, in the process I went to
drain the gear oil from the Saildrive and had mistakenly pulled the Shaft Screw
and now I can�t get it to go back in. I read the manual on how to remove the
screw, but it list no tricks to re installing the screw. Any suggestions? |
|
 |
|
|
Bill Layton
Commodore
Joined: 15 September 2002 Location: Canada Status: Offline Points: 551 |
Post Options
Thanks(0)
Quote Reply
Posted: 05 October 2015 at 8:34pm |
|
Get an awl and a flashlight... look into the hole and you'll see a hole in a fork. Push the awl into place and move it so that the hole in the fork lines up with the hole where the screw goes in and your ready to install the screw. Remember there is a paper gasket behind the head of that screw. Be sure it looks in good shape and use a bit of automotive sealant behind the head of the screw for safety sake.
|
|
|
|
|
Seawolf
Commodore
Joined: 15 March 2012 Location: missoula Status: Offline Points: 118 |
Post Options
Thanks(0)
Quote Reply
Posted: 08 October 2015 at 9:03pm |
|
Thanks for info!
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options