Engine pull start

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   One of my favorite things about the bukh is you can pull start it.  In fact, I've completely ran the engine out of fuel, then left the battery on for a week to die, and was able to prime the engine and start it all with a few yanks of pull cord. 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
khardy Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 22 June 2004 Location: United States Status: Offline Points: 132	Post Options Post Reply Quote khardy Report Post Thanks(0) Quote Reply Topic: Engine pull start Posted: 07 May 2015 at 1:19pm
	One of my favorite things about the bukh is you can pull start it. In fact, I've completely ran the engine out of fuel, then left the battery on for a week to die, and was able to prime the engine and start it all with a few yanks of pull cord.

frfletch Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 13 May 2008 Location: Canada Status: Offline Points: 365	Post Options Post Reply Quote frfletch Report Post Thanks(0) Quote Reply Posted: 06 May 2015 at 10:42am
	I was wondering about that. Thanks for that guideline Bill, though I hope I never have to use it.

Bill Layton Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 15 September 2002 Location: Canada Status: Offline Points: 551	Post Options Post Reply Quote Bill Layton Report Post Thanks(0) Quote Reply Posted: 06 May 2015 at 10:34am
	The method to use is to wrap the flywheel with a pull cord that has a handle. Then rotate the flywheel backwards until you have compression and stop. Now you can pull to start it. This allows you to get a full crank rotation before compression kicks in. If you don't do this, it feels like your ripping your fingers off and the engine won't start.

frfletch Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 13 May 2008 Location: Canada Status: Offline Points: 365	Post Options Post Reply Quote frfletch Report Post Thanks(0) Quote Reply Posted: 05 May 2015 at 11:48pm
	Chris, There is a notch on the rope groove of the flywheel to support a pull rope start, much like on an old lawn mower. It just requires a figure 8 knot in the end of about a 1/4" line that you wrap around inside the groove the the flywheel.

Winner Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 07 September 2011 Status: Offline Points: 223	Post Options Post Reply Quote Winner Report Post Thanks(0) Quote Reply Posted: 05 May 2015 at 1:18pm
	This may be one of those questions with a ridiculously simple answer but my search of old forum posts turned up nothing. Is there a specific procedure for pull starting the engine? Note that my engine has had an external alternator installed by the previous owner. See: https://www.dropbox.com/s/dad1h0kbl7ztlpe/DSC02800.JPG?dl=0 Not sure if the v-belt from the alternator on the top of the flywheel is normally where you wrap the rope for the pull start? I've tried wrapping around the large flywheel but the rope just seems to slip off.
	Chris Eclipse #240 Thunder Bay, ON